Fiat SCUDO - Page 139

137
Driving
6
steering column automatically unlocks (you may
hear a sound and feel the steering wheel move).
Switching o󰀨
► If using a conventional or remote control
key, turn the key fully to position 1 (Stop).
► If using Keyless Entry and Start, press the
"START/STOP" button.
Before exiting the vehicle, check that:
– The drive selector is in mode P.
– The READY indicator lamp is o󰀨.
The drive selector moves automatically
to mode P when the motor is switched o󰀨
or when the driver's door is opened.
If the driver's door is opened while the
required conditions for switching o󰀨 are
not met, an audible signal is emitted,
accompanied by the display of a warning
message.
Special case with Keyless
Entry and Start
Switching on the ignition without
starting the engine
With the "Keyless Entry and Start"
electronic key inside the vehicle, pressing
the "START/STOP" button, without depressing
any of the pedals, allows the ignition to be
switched on.
► Press this button again to switch o󰀨 the
ignition and allow the vehicle to be locked.
Back-up starting
A back-up reader is tted to the steering column,
to enable the engine to be started if the system
fails to detect the key in the recognition zone, or
if the battery in the electronic key is at.
► Place and hold the remote control against the
back-up reader.
► With a manual gearbox, place the gear lever
in neutral, then fully depress the clutch pedal.
► With an automatic gearbox or a drive
selector, select mode P, then depress the brake
pedal.
► Press the "START/STOP" button.
The engine starts.
Remote control not recognised
If the remote control is no longer in the
recognition zone, a message appears on the
instrument panel when closing a door or trying to
switch o󰀨 the engine.
► Press the "START/STOP" button for about
3 seconds to conrm switching o󰀨 the engine,
then contact a Fiat Dealership or a qualied
workshop.
Forced switch-o󰀨 (also called
Back-up switch-o󰀨)
In case of emergency only, the engine can be
switched o󰀨 without conditions (even when
driving).
► To do this, press and hold the "START/
STOP" button for about 5 seconds.
In this case, the steering column locks as soon
as the vehicle stops.
"Key o󰀨" mode
"Key o󰀨" mode allows you to lock the vehicle
while leaving the engine running without the
key or Keyless Entry and Start being inside the
vehicle.
This mode allows electrical devices to continue
operating to ensure thermal comfort, vehicle
security and operation of the vehicle systems
needed for the task.
KEY
OFF
► To activate or deactivate this mode, press this
button (the button's indicator lamp is on when
the mode is activated).
Fiat.K0-Fiat-VP.2021.01.en-GB.indb 137 14/02/2022 15:33:33