Fiat SCUDO - Rear Seat and Bench Seat on Rails; Adjusting the Angle of the Backrest

60
Ease of use and comfort
► Remove the seat through the side door for
row 2 or from the rear for row 3.
Retting
(example of an individual seat)
► Check that there is no object obstructing the
anchorage points and preventing the feet locking
correctly into place.
► Engage the front feet in the anchorage points
on the oor (as shown above).
► Lock the front feet using the levers.
► Tilt the seat towards the rear until the rear
feet lock into place.
Be careful of passengers' feet during the
manoeuvre.
► If tted to your vehicle, pull the control and
raise the backrest (from the rear, lower the
lever).
Check that the seat has correctly
engaged in its anchorage points on the
oor when returned to the sitting position.
Rear seat and bench seat
on rails
Feel, Shine, Business Lounge
The di󰀨erent equipment and settings described
hereafter vary according to the version and the
conguration of your vehicle.
The individual seat is always on the right and the
bench seat on the left (facing forward).
The seat has an independent backrest and the
bench seat has two independent backrests.
For more information on the Seat belts,
refer to the corresponding section.
Adjusting the angle of the
backrest
The reclining backrest can be adjusted to several
positions.
► To recline the backrest, pull the control
upwards (from the rear, lower the handle).
Fiat.K0-Fiat-VP.2021.01.en-GB.indb 60 14/02/2022 15:33:14