Fiat X 1/9 1978 - IGNITION DISTRIBUTOR

Adjust clearance as necessary by replacing tappet
plates (1).
After adjusting, install camshaft cover.
Connect throttle rod and hoses.
Install air cleaner. Install spark plugs.
1. Tappet plate. 2. Tool.
IGNITION DISTRIBUTOR
Release
2
Spring
clips
holding
cap
on
distributor.
Re-
move cap and rotor. Clean and inspect cap and rotor.
Replace cap and rotor as necessary. Lubricate distrib-
utor by adding a little oil thru wick.
1. Wick. 2. Contact points.
Check contact points (1) for wear and damage.
Check point gap (2).
Gap—0.015
to
0.017
in.
(0.37
to
0.43mm)
Adjust point gap.
Check condenser (3). Replace as necessary.
NOTE:
Replacement
of
contact
points
should
be
per-
formed
on
the
bench
with
the
distributor
removed.
1. Contact point. 2. Pointgap. 3. Condenser.
Page 10