FIBARO Smoke Sensor Short Service Guide

STEP 4. Manual self-test.
The Fibaro Smoke Sensor can automatically detect a malfunction. If malfunction is detected
an intermittent sound signal will start and alarm will be sent to the main Z-Wave controller.
Self-test may also be triggered automatically. Please, follow:
-make sure the battery is in place;
-press and hold B-button until the visual indicator glows white and short alarm sounds. After
3 seconds from the first beep smoke chamber operation will be checked.
Triggering fire alarm and beep mean positive result and should occur within 10 seconds.
Trouble signal or no fire alarm mean that the sensor is malfunctioning.
STEP 5. Contact with service.
If only one of steps above has failed, please contact with Fibaro Servicedesk at:
servicedesk@fibaro.com

FIBARO Smoke Sensor Specifications

General

Sensor Type	Photoelectric
Battery Type	CR123A
Wireless Technology	Z-Wave
Operating Temperature	0°C to 55°C
Dimensions	65 x 28 mm
Alarm Sound Level	85 dB
Radio Frequency	868.4 MHz (EU) / 908.4 MHz (US)
Humidity Range	0% to 93% (non-condensing)
Range	Up to 50 meters outdoors
Sensitivity	EN 14604:2005
Certifications	EN 14604