4 Web Configuration Guide
1. Select Security in the navigation bar and select Firewall→URL
Filtering in the left link bar, and then click Add to open the URL
filtering table configuration tab, as shown in Figure 4.13.
Figure 4.13 URL Filtering
2. Configure the parameters relevant to filtering as required. Table
4.7 describes the parameters.
3. Click Apply to save and apply the configuration.
Table 4.7 Parameters for URL Filtering Parameters
Item Description
Enable
Enables or disables the URL filtering
function.
After setting,
click Apply
below to take
effect.
URL
Blacklist /
Whitelist
Select the filtering mode. The white list and
black list modes are global configuration,
which cannot be enabled simultaneously.
u Whitelist indicates that the data
complying with the rules defined in the
filtering rule table will be allowed to
pass.
u Blacklist indicates that the data
48
To Next Page
Loading...
Need help?
General
