EN General safety instructions | Specific safety instructions
Service
Do not change parts of the tool, do not perform repairs on your own and do not interfere with
the tool’s construction in any way. Leave tool repairs to qualified persons.
Each repair or product modification performed without our company’s permission is
inadmissible (it can cause injury or harm to the user).
Always leave tools to be repaired in a certified service centre. Use only original or
recommended spare parts. This will ensure your and your tool’s safety.
5. SPECIAL SAFETY INSTRUCTIONS
WARNING!
Safety warning for works such as grinding, surfacing, wire brushing,
polishing or abrasive cutting
Before use, please read these safety instructions and keep them
in a safe place.
Upon failure to follow the instructions specified in this manual, there is a risk of injury.
Angle grinder conforms to applicable technical regulations and standards.
These electro-mechanical tools are intended for use as grinder, surface grinder, wire
brusher, polisher or cutting tool. It is necessary to read all safety warnings, instructions,
illustrations and specifications for the electro-mechanical tools. Non-compliance with
the below mentioned instructions can lead to injury by electrical current, fire and/or
serious injury.
It is not recommended to use the tools for works such as grinding, surfacing, wire
brushing, polishing or cutting. Using the tools for work, for which it is not designed,
may cause risks and injury of persons.
Accessories not specifically designed and recommended by the tool's manufacturer
may not be used. The mere fact, that an accessory can be connected to your tool
does not guarantee its safe operation.
The nominal speed of the accessory has to be at least equal the maximal speed marked
on the tool. Accessories, operating at higher speeds than its nominal speed, can break
and fall apart.
The outer diameter and thickness of the accessory has to be within the limits of the
nominal range for particular electromechanical tools. The accessories of incorrect size
cannot be sufficiently guarded or controlled.
Chucking dimensions of disks, flanges, support blocks or other accessories have to be
suitable for the tool's spindle. The accessories with chucking holes, which do not match
the assembly dimensions of electromechanical tools, will be unbalanced, can generate
excessive vibrations and can cause loss of control.
FDB 2001-E
To Next Page
Loading...