Fifine T732 - Page 4

4
What’s in the Box?
1. Shock mount
2. Microphone
3. C-Clamp
4. Windscreen
Cap
5. 3/8” to 5/8”
Adapter
6. Desktop Boom Arm 7. Pop Filter 8. 2.5 m USB
Cable
9. Tripod Stand
10. Pivot Mount
Metal Ring
Install the Microphone stand on the Table
1. Screw the lower part of the C-clamp until it is tight and secure
2. Insert the boom arm (the end without screw) into the hole of C-clamp
3. Tighten the screw
4. Screw the shock mount to the boom arm via the included adapter
Note: DON'T rotate the boom arm when the screw on the C- clamp is tightened. Loose
the screw first, adjust the position of the arm, and then tighten it.
Mount to your desktop via the included C-clamp accurately:
Unscrew the C-clamp and slide it over the side of your desktop, making sure that both
the top of the C-clamp and the underside are resting on flat surfaces. Overly rounded or
overhanging desktop edges do not make good mounting surfaces.