28
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information
SAR tests are conducted using standard operating positions accepted by the FCC with the
phone transmitting at its highest certified power level in all tested frequency bands,although
the SAR is determined at the highest certified power level, the actual SAR level of the
phonewhile operating can be well below the maximum value, in general, the closer you are
to awireless base station antenna, the lower the power output.
Before a new model phone is a available for sale to the public, it must be tested and certified
tothe FCC that it does not exceed the exposure limit established by the FCC, Tests for each
phone are performed in positions and locations (e.g. at the ear and worn on the body)as
required by the FCC.
For body worn operation, this model phone has been tested and meets the FCC RF
exposure guidelines when used with an accessory designated for this product or when used
with an accessory that Contains no metal and that positions the handset a minimum of 1.0
cm from the body.
Non-compliance with the above restrictions may result in violation of RF exposure
guidelines.
To Previous Page
Loading...