① Open the quick release, adjust the handlebar to the right
position. Lift the stem and close the stem clamp to settle it.
③ Adjust the handlebar direction, to make it at an angle of 15°-20° with the horizontal line, then close the quick release,
to complete the unfolding stem.
② Close the stem clamp and turn the safety hook into the
stem clamp.Adjust the handlebar to suitable height and
close the quick release of the stem.
Caution: The safety line should be within the stem.
Caution: Please operate by the instruction, otherwise
may cause wire breaking.
15°-20°
2.1 Installation guide
Unfold the stem
The basic installation of the bike has been completed before out of the factory. When you receive the bike, you only
need to unfold the bike, install the seat and pedals.
7
To Next Page
Loading...
