Please take corresponding protection before starting riding.
The left side is front brake, the right side is rear brake.（The UK version: Left side for rear brake,
right side for front brake.）
Step 4：Start riding
Step 5：Braking introduction
Step 3：Mode switching
Switch and choose the riding mode according to the cycling road conditions and personal needs.
① Electric mode：Equipped with pure electric mode, gently press down the electric mode button to switch
to the pure electric mode, the stonger the press, the faster the speed
② Power assisted mode：Equipped with 3 power assisted gears, click the power assisted gear button to
switch the gear. The 1st gear is suitable for relatively flat road conditions, the more/higher the road slope,
the larger gear can be adjusted accordingly.
Attention: When the bike is on PAS 3 status, click the power assisted gear button again and the bike will be on
PAS 0 status, by then the gear display wont't be lighted and the The motor will be tuen off.But other components
can work as well. The bike will be on pedalling mode.
11
While riding, it’s recommended to use the rear brakefirst, then the front brake to slow down the speed to stop,
in order to avoid falling accident caused by balance problems from urgent front wheel brake.
To Next Page
