2.1 Installation guide
lnstall the handlebar
The basic installation of the bike has been completed before out ofr the factory.When you receive the bike.you only need to
install the handlebar.baskets,headlight, front wheel,pedals and lock the aeat saddle.
① Remove the protective sleeve from the fork riser:
Use the hexagonal tool to unscrew the riser screw and
removethe protective sleeve.
③ Lock the stem: Use the hexagonal tool
to lock the stem screws firmly to avoid loosening.
④ Adjust the bike front：Adjust the front of the bike like
theabove picture, align the stem with the front wheel,
make sure they are in the same line and then lock the
screw on theleft and right sides of the handle in turn.
② Install the stem: Align the stem with steerer tube and.
7
1
2
3 4
To Next Page
Loading...
