Step 4：Start riding
Please take corresponding protection before starting riding.
Step 3：Adjust the power assisted gear
Switch and choose the riding mode according to the cycling road conditions and personal needs.
① Electric mode：Equipped with pure electric mode, gently press down the electric mode button to switch
to the pure electric mode, the stronger the press, the faster the speed
② Power assisted mode：Equipped with 3/5 power assisted gears, click the power assisted gear button to
switch the gear. The 1st gear is suitable for relatively flat road conditions, the more/higher the road slope,
the larger gear can be adjusted accordingly.
13
Step 5：Braking introduction
The left side is front brake, the right side is rear brake.（The UK version: Left side for rear brake
right side for front brake.）
While riding, it’s recommended to use the rear brakefirst, then the front brake to slow down the speed to stop, in
order to avoid falling accident caused by balance problems from urgent front wheel brake.
Attention: When the bike is on PAS 3/5 status, click the power assisted gear button again and the bike will be on
PAS 0 status, by then the gear display wont't be lighted and the The motor will be tuen off.But other components
can work as well. The bike will be on pedalling mode.
The bike has been factory settings in 3 power-assisted gear, if you need to set it in 5 power-assisted gear, please
download Fiido APP and operate it.
To Next Page
Loading...
