1. DRC/DRE，compressor and Limited adjustment area
The parameters in this area are divided into 3 parts, from top to bottom, namely dynamic
adjustment, compression adjustment and limiter adjustment. The small circle in the upper left
corner of each section is the reset button. When you need to reset parameters, click this button to
restore the parameters to default.
1.1 Dynamic Adjustment
The main function of this part is to improve or reduce the dynamic performance of the track.
DRCDRE THR: Dynamically adjust the start level. When the detected signal size reaches the set
threshold (usually less than the set value), the function will take effect.
DRCDRE Attack: When the signal duration meets the start level setting threshold, the function
takes effect.
DRCDRE Release: The signal does not meet the start level setting threshold, and when the duration
reaches this set value, the function fails.
DRCDRE Ratio: Dynamically adjust the parameter proportion. The larger the value, the greater the
adjustment range.
DRCDRE Depth: Dynamically adjust the size setting. When this parameter is a negative value, it
will reduce the dynamic performance of the track (a simple understanding is to reduce the output
amplitude); when this parameter is a positive value, it will improve the dynamic performance of the
track (a simple understanding) That is to increase the output amplitude).
To Next Page
Loading...