COAX mode/OPT mode
[How to connect]
Optical / Coaxial output device -> R7 -> Headphones / Speakers
[How to Set]
1. R7 input setting: After power on the R7, hold the power button for about 2s
or drop down the menu from the status bar, then switch to the corresponding
optical / coaxial decoding mode. And access the corresponding optical /
coaxial cable to [OPTIAL IN] or [COAXIAL IN] port in the back panel of the R7.
2. R7 output setting: switch to the corresponding output port according to the
interface used, switch to [PO] on the front panel headphone out, switch to
[PRELO] or [LO] on the rear panel line-out,switch to [PO+PRELO] on the front
panel headphone out and rear panel line-out.
3. Play music from the front-end Optical / Coaxial output device and you could
enjoy the music.
Note: If there is no sound, please try other tracks to exclude the format and file
problem.
[No output from coaxial/optical output port in coaxial and optical
decoding mode?]
To Next Page
Loading...
