Filter Queen Defender - Filter Replacement; Filter Replacement Indicator; Resetting the Filter Replacement Indicator Timer

Filter Replacement
❸ Remove the Medi-Filter
®
Cartridge and Enviropure
®
Charcoal Filter. If only replacing the Enviropure
®
Charcoal Filter, remove the old charcoal filter from the
Medi-Filter
®
Cartridge and discard it.
Note: The charcoal filter is fastened with velcro.
❹ Place the new Enviropure
®
Charcoal Filter around the
outside of the Medi-Filter
®
Cartridge and fasten with
the velcro. If also replacing the Medi-Filter
®
Cartridge,
fasten the new Enviropure
®
Charcoal Filter to the new
Medi-Filter
®
Cartridge. Return the filters to the unit.
❺ Replace the top motor assembly.
❻ Place the unit on its side to secure the retaining nut on
the bottom of the unit. Return the unit to its upright
position to resume use.
❶ After unplugging the Defender
®
, place the unit on its
side and remove the retaining nut on the bottom of the
unit by turning counterclockwise.
❷ Return the unit to its upright position and lift off the
top motor assembly.
Prompt filter replacement will prevent any potential damage to your Defender
®
that
may result from its continued operation with a clogged filter condition.
To Replace your Filter(s):
ENGLISH
7