FIMAK SPM 100M - Page 80

FiMAK
MOBİL KAZANLI SPİRAL MİKSER 100M-160M-200M -250M
80
4.2 BELT TIGHTENING
In every 15 days, after
loosening the engine
tray fixing screws (A)
the tension is reduced
by the tensioning
screw (B) which is
located at the back of
the machine and then
fixing screws (A) is re-
tightened.
In every 15 days, open the
grill cover and loosen the
tension belt and also check
the tension of engine tray.
In every 15 days, open the
vent shutter cover and
tighten the tension screw,
also check the tension of
belts by hand.
Maintenance Instructions
A
B