Operation
Connect the power cable to a 13 amp supply that is located in a safe, dry area.
• The switch on the heater head is used to control the four heat setting. (0) for OFF
(1) for 650w - (2) for 1350w - (3) for 2000w. Although the patio heater is shower
proof, do not use when raining or in wet conditions.
• Always disconnect the power cable from the electrical supply, when the patio
heater is not in use.
Care and maintenance
• When disconnected from the electrical supply, clean the outside of the patio heater
with a damp cloth. Never use corrosive or solvent cleaners or immerse in water.
• Any maintenance or repairs including replacing the halogen tube should only be
carried out by a qualied electrician or by a recommended service center.
Technical specication
• Power supply 240V ~ 50Hz
• Wattage max 2000w
• Net weight ~9kg
• Insulation class I
• Height 120cm - 210cm
Unpack the halogen heater making sure that all the items are
present and that there are no components left in the box and that
the heater head is free from any packing material.
Using the detailed drawing follow the steps to assemble your
halogen heater.
Do not connect the halogen heater to the electrical supply until all
the assembly is complete.
Do not connect the halogen heater to the electrical supply if any
of the components or the power cord is damaged in any way.
If in doubt contact your supplier.
Primrose
info@primrose.co.uk
Tel:0118 9035210(UK)
Tel: 0044 118 9035210(outside of UK)
To Previous Page
Loading...
Need help?
General