This system features a Service Mode to be used by qualified technician. Once enabled, it will remove
the 5-second hold delays on:
• Gen Hours Reset
• Individual Wireless Switch Pairing
• Clear All Wireless Switch Pairing
• Floorplan Selection
To enable Service Mode, Press and hold the Settings button for 5 seconds until a yellow wrench appears
at the top right-hand corner of the screen (next to the time). Now, release your finger and the Warning
screen will appear. Once you tap enable, the wrench will turn Red.
To disable Service mode, tap the red wrench, then tap Disable from the warning screen.
To Next Page
Loading...