AGS WARNING – to ensure safety, AGS will not be activated
until you hold the Enable button (from the Warning screen)
for at least 3 seconds.
Set Gen Hours - Press and Hold the
gen hours display to enter the Set Gen
Hours screen. Tap the buttons to
enter your desired hours then tap Yes
to save and exit.
House Voltage – the
voltage coming from your
house batteries. Note:
Battery graphics will display
Red if below 12V.
Chassis Voltage – the
voltage coming from your
engine battery.
Generator Start - hold Start to start
the generator (1 second delay).
Generator Stop – Hold Stop to stop
the generator.
Tap to Enable/Disable AGS.
If AGS is enabled before the coach is connected to shore
power, the Shore Override status message will be
displayed and AGS will be disabled. AGS will
automatically re-enable once shore power has been
disconnected.
To Next Page
Loading...