DUAL AIR CONTROL PANEL 1
COMPRESSOR 1
COMPRESSOR BRACKET 1
30 FT. AIR LINE TUBING 1
15 FT. 18 GAGE WIRE 1
10/32" X 1" MACHINE SCREW 2
10/32" LOCK NUT 2
1/4" X 1" HEX BOLT 2
1/4" HEX NUT 2
1/4" LOCK WASHER 2
1/8" NPT STRAIGHT FITTING 1
FUSE HOLDER 1
20 AMP. FUSE 1
FEMALE SPADE CONNECTOR 3
MALE SPADE CONNECTOR 1
WIRE CONNECTOR 2
RING TERMINAL 2
FOAM PAD 1
#10 FLAT WASHER 4
NYLON TIES 16
DUAL ELECTRIC AIR COMMAND
24-8143 03-01 NCD-5965-1
2178
P
ARTS LIST
I
NSTALLATION INSTRUCTIONS
Congratulations on your purchase of a new Firestone Air
Control Accessory Kit. This kit was designed to provide
inflation control of your Firestone air helper springs. This kit
will be an asset to your vehicle, meeting most all of your air
supply needs.
Please take a few minutes to read through the instructions,
identify the components, and learn how to properly install your
Air Control Accessory Kit.
N
OTE
:
The Air Control Accessory kit can be used with all
Firestone air helper springs products. If you are installing a
Firestone suspension system do not install the air line tubing
into the air springs as stated in the suspension system instruc-
tion manual. If you are adding the Air Control Accessory kit
to an existing Firestone suspension system you will need to
deflate the air springs and remove the air line tubing.
AIR CONTROL ACCESSORY KIT
N
OTE ON
C
ONNECTING THE AIR LINE TUBING
Cut the air line tubing as squarely as possible. To
connect the air line tubing to the fittings push the tubing
into the fittings as far as possible. If for any reason the
tubing must be removed the collar of the fitting can be
pushed toward the body of the fitting and the tubing can
be removed. Make sure the air helper springs are de-
flated. To reassemble make sure the tubing is cut squarely
and push back into the fitting.
T
OOLS REQUIRED
:
• 3/16" drill bit • 3/8" drill bit
• 1/4" drill bit • Hand drill
• Electrical pliers • Pliers
• Phillips screw driver • Sharp knife
• (2) 7/16" wrenches • Center punch
0 150
30
120
60 90
200
400
600
800
1000
psi
kPa
PSI