Change to Preset 1, 2, or 3 and Turn Heater On:
Click the button 1, 2 or 3 times quickly to select preset 1, 2, or 3 then
hold down the button. The selected preset will be saved and the
heater will turn on.
Check Current Preset:
Click the button 2 times quickly. The
vaporizer will buzz quickly 1, 2, or 3
times to indicate the current preset.
Check Temperature for Current
Preset:
Click the button 3 times quickly. The
vaporizer will give 2 sets of buzzes.
The 1
st
buzz gives the hundreds place
and the 2
nd
buzz gives the tens place (in
degrees F) as shown in the table to the
right.
Set Temperature for Current Preset:
Click the button 4 times quickly. The
vaporizer will buzz back 4 times quickly.
Using the table to the right, select the
temperature by clicking as indicated.
For example, to set the temperature to
390, click 4 times to start and wait for 4
buzzes. Then click 3 times and wait for
3 buzzes back. Then click 9 times to
finish.
Tips On Drawing:
The Firewood 7 uses a combination of
conduction and convection to heat your
botanicals. The conduction is the heat
transfer from the walls of the oven directly into the botanicals and
occurs whether or not you are drawing. The convection is the heat
transfer from hot air to your botanicals after passing through the
heating element and occurs only when you are drawing. By varying
your draw speed and timing you can vary the balance between
conduction and convection. Starting your draw early (before the
ready-buzz) and drawing faster causes more convection while starting
your draw after the ready-buzz and drawing slow causes more
conduction. Please keep in mind:
• Conduction heats the outside edges
• Convection heats the inside
• Drawing too fast can pull too much heat past the oven and cause
the mouthpiece to overheat
• Drawing too fast can cause your botanical oils to move out of the
oven area before getting a chance to vaporize, reducing efficiency
• Drawing too slowly can cause excess conduction and charring at
the edges
• Experiment to find your best results!
Cleaning:
For best results, clear the oven after each use while still warm by
removing the lid and blowing through the mouthpiece to eject the
contents. Whenever possible, carefully wipe down the ceramic
surfaces on the lid, oven, and mouthpiece while still warm. Doing so
while still warm allows stubborn resins to be removed without alcohol.
The glass and ceramic mouthpiece
part should be removed and
cleaned occasionally. Start by
removing the wooden mouthpiece
attachment. If the mouthpiece is
stuck due to resin buildup, it can
be easily loosened by warming up
the device before removing.
Remove the glass tube and
clean with alcohol (or other
solvent) and pipe cleaner.
Then remove the ceramic
mouth-piece part and clean
with a cotton swab and
alcohol.
Finishing & Maintaining the
Wood Surface:
Firewood vaporizers come either unfinished or with a 100% natural Tung Oil
finish. For best results, unfinished wood should be sanded and finished with a
natural oil/wax finish. Finished wood can be restored by lightly sanding and
reapplying a fresh oat of the original finish.
Warranty: Firewood Vaporizers Inc. One (1) Year Limited Warranty Information
Firewood Vaporizers Inc. grants purchasers of the Firewood Vaporizer a warranty
against defects in materials and workmanship under normal use of the device for
a period of one (1) year from the date of retail purchase by the original purchaser
of the unit. If a physical defect arises and a claim is received within the Warranty
Period Firewood Vaporizer Inc. will either (1) repair the device, (2) exchange the
device, or (3) refund the purchase price of the device, at the discretion of the
company.
Exclusions and Limitations :
The Limited Warranty applies only to devices manufactured by Firewood
Vaporizer Inc. This warranty does not apply to: (a) to damage caused by accident,
abuse, misuse, or other external causes; (b) to damage caused by operating the
device outside the permitted or intended uses; (c) to a device or part that has
been modified to alter functionality or capability; (d) to cosmetic damage,
including but not limited to scratches, dents, and discolored wood; (e) to damage
caused by use of unapproved batteries, charger or power supply; (f) damage to
ceramic parts after 1 month from the purchase date.
The Warranty does not apply to normal performance degradation of batteries,
neglecting to adhere to cleaning instructions, or heat damage due to improper use
of the device. Intentionally disassembling or attempting repairs on your device will
void the warranty.
Please email service@firewoodvapes.com for warranty service. Please include a
description of the problem and the Name and Date of purchase.
To Previous Page
Loading...