DESCRIPTION

The Fireye BurnerPRO is a compact, microprocessor based, primary flame safeguard control system

designed to provide the proper burner sequencing, ignition and flame monitoring for on-off, multi-

stage, or modulating burners used in commercial heating and process equipment firing oil and gas

fuels. The BurnerPRO flame safeguard offers two built-in amplifiers, which allows for use in UV

only, FR only, and UV+FR applications. Flame monitoring for UV is accomplished by using avail-

able UV scanners: UV90L, UV1AL & UV5. Flame monitoring for FR version is accomplished by

using available ionization rod: 69ND1. The FR amplifier circuitry is subjected to permanent self-

checking, which allows it for use in applications that require burner cycle that runs for more than 24

hours. When operated as a UV control, the system is considered non-permanent, which requires a

burner recycle at least once every 24 hours.

The valve proving feature checks for leakage through the safety shutoff valves prior to burner start-

up or immediately after a burner shutdown. The Modbus interface provides the ability to write cus-

tom timing parameters, as well as reading status information during burner operation.

Through seven SMART LEDs, the control provides current operating status and lockout information

in the event of a safety shutdown. Refer to the BurnerPRO ordering information section in this docu-

ment for the various combinations of control functions and timings.

A complete BurnerPRO system includes the BP110/230, flame scanner and wiring base. The Burn-

erPRO performs a safe-start check on every burner cycle. If flame is detected prior to a start or

during the purge cycle, the fuel valves are not energized and the control locks out. The ‘POC’ input

is also monitored to verify that the main fuel valves are always in the proper state prior to the start of

a burner cycle. The LEDs & alarm terminal are used to annunciate the presence of a lockout condi-

tion.

Expanded functions of the BurnerPRO:

• Non-volatile lockout capability

• Air-flow proving, Gas valve proving, & Modbus access

• A run/check feature allows the operator to stop the program sequence in different

positions (Purge, Ignition, PTFI, MTFI, AUTO) for system troubleshooting

• Modbus, Remote and local Reset ability

• Two built-in amplifiers (UV, FR, UV+FR) for flexibility in applications

• Smart LEDs provide on board diagnostic lockout information

• Extended temperature operation (-40°C to 60°C)

• High capacity relay contacts

FIREYE

BurnerPRO

™

MICROPROCESSOR-BASED

INTEGRATED BURNER

MANAGEMENT CONTROL

with UV & FR Flame Amplifiers,

Valve Proving Feature and Modbus Interface

BP-1003

SEPTEMBER 21, 2018

Fireye BurnerPRO - Troubleshooting Manual

Other manuals for Fireye BurnerPRO