English Customer Service: 1-844-FIRMAN1
17
6. Move choke lever located on engine to “START” position. You do not need to choke a warm engine.
(For electric start move to step (8))
7. For recoil start only - Pull the starter cord slowly until resistance is felt and then pull rapidly to
start engine.
8. For electric start only - Flip the engine switch to the START (ll) position for a few seconds and
then release.
3 sec.
OPERATION
5. Disconnect all electrical loads from the generator. Never start or stop the generator with
electrical devices plugged in.
9. Do not over-choke. As soon as engine starts and warms up, slowly move the choke lever to the
RUN position.
To Next Page
Loading...
