FEATURES
The First Alert model number ZCOMBO (Cat. 1044807) is a single station
combination smoke and CO alarm specifically designed for residential applications.
First Alert ZCOMBO has been fully tested to and complies with UL217, UL 2034,
CSFM, FCC, IC, Z Wave Plus, NFPA 72, NFPA 720 and other agencies that model
their codes after the above agencies. It meets building codes where battery
operated Z-Wave wireless smoke and CO alarms are required along with silence
features and with model building codes.
First Alert ZCOMBO is a state-of-the-art wireless combination smoke and CO alarm
designed to provide early warning of a fire or CO. It features a fully insect screened
Photoelectric smoke sensing chamber and an electrochemical carbon monoxide
sensor, an 85dB horn, a supervised 3V (2 AA batteries) power supply, utilizes one test
button to setup, test and silence. This combination alarm will operate with 3rd party,
certified Z-Wave devices enabled with the First Alert protocol and the basic command
class required by all Z-Wave devices. First Alert ZCOMBO also includes the Smart
Start feature which allows a faster and more intuitive connection of device to hub and
on-boarding via use of QR code scan located on device. By the requirements of the
Device Class spec, this command class does not have to be mapped to any particular
functionality for this device. The alarm supports one association group with up to 1
node and sends its alarms to that group. The alarm supports configuration parameter
#1, which has a size of 1, a default value of 0, and when set to 1 causes the device to
send double alarm messages. Upon the detection of smoke or CO conditions, the
alarm reports smoke and or CO detected to the controller. The device shall send the
applicable message when the conditions are cleared. These notifications must be
wrapped in the Supervision CC. The following notifications must be supported. The
alarm sends a “Heartbeat” signal to hub periodically to confirm operability.
It also features tamper resistant locking pins that lock alarm to the mounting
bracket and battery drawer to prevent removal of battery or alarm. Designed for
wall or ceiling mounting. Includes mounting anchors and screws.
ZWave Compatible
Stay Connected Through
Your ZWave System
2-in-1 Protection
Smoke/Fire & Carbon
Monoxide Alarm
Photoelectric
Smoke Sensor
Meets UL217
and UL2034
Standards for Smoke
and CO Alarms
Test & Silence
Button
For Efficient Testing
Model ZCOMBO
Cat. 1044807
Model ZCOMBO
Cat. 1044807
2
IN
1
Smoke & Carbon
Monoxide Alarm
To Next Page
Need help?
General
