Installation instructions:
1
Ensure the refrigerator is NOT plugged into
a powersupply.
2
Locate a cold water supply/feed that is
suitable for a water connection.
3
Connect the tap connection fitting (
A
) to
the tap. Connect the short tubing (
B
) to
the outlet of the tap and secure with the
locking key (
C
) (refer to Diagram 1)
4
Connect the inlet of the PRV (
D
) to the
tubing connected to the tap (refer to
Diagram 2). Ensure the arrow on the PRV
is pointing away from the tap. The arrow
indicates the direction of waterflow.
5
Connect the inlet tube from the filter head
to the PRV (refer to Diagram 3). The inlet
tube can be identified by the downward
arrow on the filter head and a red mark
on the tube.
IMPORTANT!
Ensure the outlet tubing is correctly
connected to the refrigerator water valve.
Refer to Diagram 3.
6
Determine the mounting position for the
water filter noting the following:
The water filter MUST not be mounted
with the filter head position below the
base of the filter (refer to Diagram 4).
We recommend fitting the water filter
in a vertical orientation with the filter
head at the top. This will minimise water
leakage during replacement of the
waterfilter.
Ensure the water filter is in a convenient
location to access every 6months
for replacement. We recommend that
this location is beside the water filter
supply tap in a cupboard beside the
refrigerator.
A minimum clearance of 50mm from the
bottom of the water filter is required to
perform filter removal.
Diagram 1
Inlet
tube
Diagram 2
Diagram 3
0° – 90°
Diagram 4
water flow
from PRV
water flow to
refrigerator
To Next Page
Loading...
