17
!7 HANGING DOOR PANELS (ICE & WATER MODELS ONLY)
7 Firmly push the water tube into
the spigot behind the door panel
until the marked line is not visible.
Ensure water tube is routed away
from any sharp objects, sharp
corners (beware of kinking the
tube as this will stop water flow),
and not in a location where it can
be kinked or squashed when door
panel is secured.
Secure door panel following the
instructions on the previous page.
5 Connect display harness
onto the refrigerator door by
inserting firmly until you feel
it clip securely.
3 Remove water tube from holder
on the refrigerator door.
6 Enable the dispenser lock to prevent any water from
dispensing during water connection. To lock, press the
button for 4seconds. The LED above the button will illuminate.
2 Angle top display tabs into the
door panel. Ensure the harness
is free of pinching. Firmly push
against bottom display tabs
and insert into the door panel
until you feel it clip securely.
Ensure the display is flush with
the door panel.
1 Remove the external display
module from inside the product.
Thread the display harness
through the door panel cavity.
Ensure the grommet is engaged.
4 Hang door panel onto the top
studs. Ensure the panel is free
to pivot for water connections.
To Next Page
Loading...
