Fisher & Paykel ACTIVESMART RS9120W - ALIGN YOUR PRODUCT INSIDE CABINETRY; Height Adjustment and Flushness Check

20
IMPORTANT!

Ensure that all four corners of the refrigerator are supported firmly onto the floor
toeliminate any movement.

Installing the refrigerator on a soft, uneven, or not level floor may result in twisting
oftheproduct and poor door sealing.

Raise the refrigerator using a 11mm hex socket or 4mm allen key. One turn of height
adjusting nuts is equivalent to 1mm height travel.
Note: Maximum turn is 20mm.

Use low torque setting to avoid damage to height adjustment system.

Failure to achieve flushness across all sides greater than 1.5mm can lead to difficulties
achieving final alignment. Final alignment will be achieved once door panels have
beeninstalled and the refrigerator is pushed back to sit flush with cabinetry.
1
Turn the front and rear adjustment nuts
(A) using a allen key to extend the feet
until it engages the floor.
– Clockwise turn raises the height
and counter-clockwise turn lowers
the height.
2
Continue turning the adjusting screws
alternately between front and rear feet
to align the front of the doors top to
bottom on both sides, and until you
achieve the correct alignment.
– Depending on your installation
design, alignment may be flush
with your adjacent cabinetry or
your framework.
C
A A
Front roller adjustment
Rear roller adjustment
Place a ruler on the front of
the product to check flushness
top and bottom, left and right.
B
3
Place a ruler on the front of the product (B) to check flushness
top and bottom, left and right. Check the gaps between
refrigerator and adjacent cabinetry are even on both sides (C).
– This step will help ensure the refrigerator is level with the
adjacent cabinetry.
4
Gently push the front of the product to check the stability.
!5 ALIGN YOUR PRODUCT INSIDE CABINETRY