8
The unique AquaSmart 2™ wash
The AquaSmart 2™ washer has two modes of washing, High Efficiency and Conventional.
Both modes start the same way, with a Detergent Activating wash.
Detergent Activating wash
AquaSmart 2™ fills the bowl at the selected water temperature, with
just enough water so the clothes are saturated. This small amount
of sudsy water flows through the clothes, up a specially designed
portal and back onto the clothes in a waterfall effect. This thoroughly
dissolves and activates the detergent.
High Efficiency mode
In the High Efficiency mode the AquaSmart 2™ then fills with just
enough cool water to lift the clothes off the low-profile agitator so
when it rotates, the clothes gently roll over each other. This wash
gives you the benefit of water savings, using similar quantities of
water to most front loaders.
Conventional mode
The Conventional mode is the immersion wash all top-load washer
users are familiar with. However, this mode still uses less water than
that of other top loaders which utilise the immersion wash. After the
Detergent Activating wash the AquaSmart 2™ fills with cold water
until the clothes are submerged, and gently turns the clothes over. We
recommend this mode when the dilution effect of water can solve or
prevent common wash problems. For example, when dye or colour run
can be a problem (ie new, dark-coloured garments), or when washing
sandy towels. The SHEETS cycle uses the Conventional mode.
Some cycles can be used in both modes, whilst others work in only one.
High Efficiency Conventional
Regular
Heavy Duty
Sheets –
Delicate
Easy Iron –
Colours –
Whites
Bulky –
These two wash modes mean that your AquaSmart 2™ washer gives you the best of both worlds,
to suit any laundry situation.
Fig.9 High Efficiency wash
Fig.10 Conventional wash
Fig.8 Detergent Activating wash
To Next Page
Loading...
