Before you service
'four cold water temperature may exceed the recommended limits (refer to
Installation instructions pages 6 - 11).
Check that the inlet hose filter is not b[ockeG
Check that the inlet hose is not kinked or squashed.
Check that the inlet hoses have been connected to the co_ect faucets.
The flow rate of the supply water may be too slow.
©
freely.
Checkthat the washer is not siphoning (refer to page 9).
'four washer has a suds build-up. Tbo much detergent may have been used for the
amount of soil in the load.
Rinse clothing using the RINSEand SPIN cycle, or run through another cycle
For a bulky bad, press down as far as possible and press START/PAUSE_
Check that the lid is c[oseG
If the symptom persists,ca[[your Fisher and Payke[Dealer or Authorized Service
Center,
Single beep every second and o.°
3. Check your washer is level (refer to installation instructions pages 6 - 11 ).
4. Remove bad and retry.
5. Put through a RINSEand SPIN cycle.
::6. If the fault re-occurs repeat steps 1 and 2.
If the washer still wi[[ not work, ca[[ your Fisher & Payke[ Dealer or Authorized Service Agent to
arrange service (refer to page 40).
To Next Page
Loading...
