Fisher & Paykel Classic Series - Fitting the Optional Backguard; Location of Electrical Supply

9
A
B
D
E
C
FITTING THE OPTIONAL BACKGUARD
Grounded outlet

The electric cord with 4-prong ground plug
(NEMA 14-50P) shall have a minimum length
of 48” (1220mm) beyond the back of the
range.
LOCATION OF ELECTRICAL SUPPLY
Final position of cooker against wall
Left side
of cavity
Floor
Electricity
D
B
A AC
SUPPLY AREA DIMENSIONS inches (mm)
A
Distance from either edge of
Range to supply area
3/16” (5)
B
Height of electrical supply area
(from floor)
2 3/16” - 4 1/8” * (55-105)*
C
Width of electrical supply areas 29 1/2” (749)
D
Depth of supply area (ie
maximum protrusion of electrical
connection from wall)
3 15/16” (100)
* Depending on adjustment of feet
A
B
D
E
C
Island trim and backguard

It is mandatory to install and use the appliance with either
the island trim or the optional backguard correctly in place.

The island trim is already fitted to the appliance while the
backguard can be purchased as a separate kit.

If replacing the island trim with the backguard, assemble it
by using the same screws/spacers used for fixing the island
trim.
7
1
GAS AND ELECTRIC CONNECTION
Fig. 1.2
Dotted line showing the position
of the range when installed
Area for
ELECTRICAL
connection
Area for
GAS connection
C
A
C
D
D
Ref. inch mm
A 2” 11/64 - 4” 9/64 (*) 55.2 - 105.2 (*)
B 2” 61/64 - 4” 59/64 (*) 75 - 125 (*)
C 14” 3/4 374.5
D 13/64” 5
(*) : Depending on feet regulation
ISLAND TRIM AND BACKGUARD
• It is mandatory to install and use the appliance
with the island trim or backguard correctly in
place.
• The island trim is already tted to the appliance
while the backguard can be purchased as a
separate kit.
• If replacing the island trim with the backguard,
assemble it by using the same screws/spacers
used for xing the island trim (gures 1.3a,
1.3b).
12 x
12 x
Fig. 1.3a
Fig. 1.3b
A
B
A
B
B
7
1
GAS AND ELECTRIC CONNECTION
Fig. 1.2
Dotted line showing the position
of the range when installed
Area for
ELECTRICAL
connection
Area for
GAS connection
C
A
C
D
D
Ref. inch mm
A 2” 11/64 - 4” 9/64 (*) 55.2 - 105.2 (*)
B 2” 61/64 - 4” 59/64 (*) 75 - 125 (*)
C 14” 3/4 374.5
D 13/64” 5
(*) : Depending on feet regulation
ISLAND TRIM AND BACKGUARD
• It is mandatory to install and use the appliance
with the island trim or backguard correctly in
place.
• The island trim is already tted to the appliance
while the backguard can be purchased as a
separate kit.
• If replacing the island trim with the backguard,
assemble it by using the same screws/spacers
used for xing the island trim (gures 1.3a,
1.3b).
12 x
12 x
Fig. 1.3a
Fig. 1.3b
A
B
A
B
B