34
Fault codes
How to recognise a fault code
When a fault has occurred, the DishDrawer® will continuously beep every second.
The fault code will be displayed on the wash programme selector.
Each fault code is shown in the following chart.
How to attend to a fault code
1
Press the / button briefly to stop the beeping.
2
Press the / button to turn the DishDrawer® off. Wait a few seconds.
3
Press the / button to turn the DishDrawer® back on.
Has the fault code disappeared?
>YES > You can continue to use your DishDrawer®.
NO
4
Note down the fault code.
5
Unplug the DishDrawer® or turn it off at the power supply.
6
Check the chart overleaf and try correcting the fault where possible, following the instructions in
the ‘What to do’ column.
Has the fault code disappeared? >YES > You can continue to use your DishDrawer®.
NO
7
Unplug the DishDrawer® or turn it off at the power supply.
8
Call your Authorised Service Centre or Customer Care and advise them of the fault code.
This information will help them respond to your request.
To Next Page
Loading...
