Fisher & Paykel DD24DCTW9 - FAULT CODES; Understanding Fault Codes; F and A Code Solutions

41
FAULT CODES
How do I know if there is a fault?
Your DishDrawer™ Dishwasher will beep continuously and a fault code will flash in the
display. There are two types of fault codes – ‘F’ and ‘A’.
Double models only
z
There may be a fault in one or both of the drawers and the fault codes may be different
in each.
z
The drawer indicator also flash to show which drawer has a fault.
z
If there is a fault in both drawers, both drawer indicators will flash.
z
If a fault occurs in one drawer only you are still able to use the other drawer. If you have
paused a drawer during a wash program, and the other drawer then faults, the paused
drawer indicator will continue flashing but will be dimmed.
To fix a fault
First try to fix the issue and clear the code according to the steps in the following tables.
If the problem persists:
1 Note down the fault code.
Double models only: Press
to scroll between the drawers and note down
the code for each drawer.
2 Contact Customer Care for support or to organize a visit by a service technician.
Refer to the Service and Warranty booklet for contact details.
‘F’ fault codes
You may be able to clear the fault by resetting the DishDrawer™ Dishwasher. Follow the
steps below:
1 Press
to stop the beeping, then again to turn the DishDrawer™ Dishwasher off.
2 Wait a few seconds. Press
again to turn the DishDrawer™ Dishwasher back on.
When the fault code has disappeared, the fault has been reset and you can continue to use
your DishDrawer™ Dishwasher.