479536
24
4.3 Cowl Replacement and Components
4.3.1 Electric Model Cowl
Control Inlet Thermostat
Safety Thermostat
Hi-limit Thermostat
Mounting Screws
• Remove the drum
• To remove the thermostats, remove the thermostat screws and unclip the thermostat from the
cowl.
• When replacing any thermostat, always replace wires in the same position as the original
thermostat. If you think it is wired incorrectly, see the cowl wiring diagram.
• Remove the element wires from the bottom of the cowl, keeping note of their position. When
refitting, if you think it is wired incorrectly, see the cowl wiring diagram.
• Undo the 4 mounting screws and remove the cowl from the rear panel.
• Undo the four screws that retain the drum-bearing retainer to remove the retainer.
Reassembly is the reverse procedure.
4.3.2 Electric Cowl Wiring Diagram
To Next Page
Loading...
