Fisher & Paykel DE09 - Gas Model Cowl; Gas Cowl Wiring Diagram

479536
25
4.3.3 Gas Model Cowl
Safety Thermostat
Control Inlet
Mounting Screws
• Remove the drum.
• To remove the safety thermostat, remove the thermostat screws and unclip the thermostat from
the cowl. To remove the control inlet thermostat, lever the leg of the thermostat towards the
centre with a flat screwdriver, then remove.
• When replacing any thermostat, always replace wires in the same position as the original
thermostat. If you think it is wired incorrectly, see the cowl wiring diagram.
• Undo the 4 mounting screws and remove the cowl from the rear panel.
• Undo the four screws that retain the drum-bearing retainer to remove the retainer.
Reassembly is the reverse procedure.
4.3.4 Gas Cowl Wiring Diagram