Fisher & Paykel DE09 - OPERATION; Control Panel and Cycle Selection

479536
29
4.6 Power Supply Connections
4.6.1 Electric Terminal Block
• Disconnect the power supply to the Dryer.
• Undo the nuts holding the mains cables to the terminal block and remove the wires.
• Undo the nuts holding the dryer supply cables keeping note of their positions.
• Remove the screws securing the terminal block and remove the block.
Reassembly is the reverse procedure. Make sure the wiring is re-installed correctly or major
damage may be caused to the dryer. Refer to the installation instructions (Section
2).
4.6.2 Gas and Electric Model Cable
(Electric cable supplied in Canada Only)
• Disconnect the power supply to the Dryer.
• Remove the power plug.
• Either remove the exhaust duct or remove the drum to access the cord connections.
• Disconnect the terminals or connector from the cable.
• Push the cable bush through the cabinet and remove the cable.
Reassembly is the reverse procedure.
5 OPERATION
5.1 Operating Instructions - Control Panel
Automatic Drying Cycles
(Cycle automatically senses dryness)
There are two automatic dryness levels: MORE DRY (+) and LESS DRY (–).
These two settings dry the clothes to different degrees depending on the level of dryness desired.
Automatic Permanent Press – For synthetic blends.
Select MORE DRY (+) for heavier fabrics, LESS DRY (–) for light fabrics.
Automatic Permanent Press – For lingerie and special care fabrics.
Select MORE DRY (+) for larger fabrics, LESS DRY (–) for smaller fabrics.
Automatic Cottons – For cottons and most linens.
For most loads select the preferred Regular Setting marked with an *. Set towards MORE DRY (+)
for heavier fabrics, LESS DRY (–) for lighter fabrics.