2. Tilt the dryer backwards and ‘walk’ it off the base one foot at a time. Not doing so may cause damage to your
floor and dryer.
3. Remove all packaging and accessories from inside the drum and ensure you remove protective covers from
the door and console.
Location
• The dryer must be installed in a well-ventilated,
dustfree environment.
• The dryer must not be installed on any textured
floor coverings (eg carpet, rugs).
• Do not install the dryer behind a lockable door,
sliding door, or behind a door where the hinge is
on the opposite side to that of the dryer in such
a way that the full opening of the door is
inhibited. Ensure the dryer door can always be
opened fully.
• Do not install the dryer outside, in a damp place,
where there is a risk of freezing, where it may be
rained on, in direct sunlight or close to a source
of heat.
• Do not place your dryer on top of its power
cable.
Venting
Correct installation is very important for all dryers to ensure maximum efficiency and safety.
Never run the dryer unless the airflow system is free from obstruction.
There must be adequate ventilation to avoid the back flow of gases into the room from appliances burning fuels,
including open fires, when operating the dryer.
Exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other
fuels.
https://producthelp.fisherpaykel.com/au/Dry/Dryers/Vented/DE4060M1/User_Guide_DE4060M1/03_Installation_Instructions
Updated: Sun, 27 Aug 2023 10:37:02 GMT
Powered by
2
To Next Page
Loading...
