to resume the cycle.
You do not need to empty the water tank if
you have set up the drain hose to drain the
water automatically.
Removing the water collection tank
To empty the water tank:
1. Remove the water tank by holding onto the handle and pulling
outwards gently to remove it. Ensure that you keep the tank level
when it is being removed to prevent the water collected from
spilling.
2. Pour the water down the sink or into a bucket, and then put the
tank back in place.
Tipping out the water condensing
tank
• Do not use the water collected in the water tank for drinking or food processing.
• Never run the dryer without the water tank in place.
• If the water tank becomes full, the tumble dryer will pause drying and will sound an
alarm. You must empty the water tank before the dryer can continue drying. Empty the
tank, replace it back in the housing then touch to resume the cycle.
https://producthelp.fisherpaykel.com/nz/Dry/Dryers/Condensing/DH8060P1/User_Guide_DH8060P1/09_Caring_for_your_dryer
Updated: Fri, 14 Feb 2020 06:11:37 GMT
Powered by
3
To Next Page
Loading...
