Fisher & Paykel DH8060P3 - FAULT CODES; Resolving Dryer Faults

38
When a continuous series of beeps sound, all the lights turn off onthe control panel and a
number appears on the display, a fault hasoccurred. The dryer will automatically enter this
mode if a fault occurs. The word Fault will be shown in the control panel display followed
by a number. To stop the beeps, press any button then perform the following steps:
1 Turn your dryer off at the power point.
2 Wait one minute and turn it back on.
3 Check your dryer is installed correctly (refer to ‘Installation instructions’).
4 Remove your load from the dryer and retry.
5 Perform a
TIME DRY cycle, eg TIME DRY for 30 minutes.
6 If the fault re-occurs repeat steps
1
and
2
.
7 If the dryer still will not work call a Fisher & Paykel trained and supported
servicetechnician to arrange service (refer to ‘Customer care’). Recordthefaultcode
number displayed and the serial number of your dryer (locatedonthe rear of the
dryer, or on the insideof the door below the glass) beforecalling. The fault code will
indicateto the service technician what the problemcould potentially be.
If a fault code is being displayed, you can still turn your dryer off by pressing
POWER .
FAULT CODES