Fisher & Paykel DISHDRAWER DD24 - Troubleshooting; Dish and Water Issues

42
6 DIAGNOSTICS
Output Display Code
Element relay (ensure there is water in the tub before running the element) Er
Lid down or up Ld
Detergent diverter dd
Fill valve FU
Wash motor direction P1
Drain motor direction P2
Rinse aid pump rd
Drying fan dF
Rinse aid LED LE
Water softener bypass valve C1
Water softener brine pump C2
Water softener brine value C3
Rinse aid pump A1
Temperature in tub 0
o
C
Fast Cycle (‘FC ’)
1 The test Fast Cycle wash program is NOT the same as a normal fast wash program.
2 Press Tub Select to choose the tub.
3 Press START/PAUSE button again to start the Fast Cycle.
4 Press START/PAUSE button again to pause the Fast Cycle.
5 Press POWER button to exit FC sub-mode to “Power off” mode.
Continuous Cycle (‘CC ’)
1 This sub mode is only used in the factory and is NOT required for servicing in the field.
2 Use the WASH SELECTOR button to go to the next sub-mode.
High Heat Cycle (‘HH ’)
1 This sub mode is only used in the factory and is NOT required for servicing in the field.
2 Use the WASH SELECTOR button to go to the next sub-mode.
Show Room Mode (‘SH ’)
1 In this mode, the user can press all the buttons. However, the user won’t be able to start a cycle.
2 This sub mode has a 30 second timeout after which it resets to “Heavy” and goes through displaying
each of the cycles.
3 Show room mode can be exited by turning the power button off on the display , then pressing and
holding the POWER and START/PAUSE button for 5 seconds.
NOTE: The showroom mode will survive a power o at the wall socket, and needs to be manually
removed to operate correctly.
Hardware Output (‘HO ’)
1The WASH SELECTOR button scrolls through various outputs.
2 Use the Tub Select button to choose what tub to run the output on.
3 Press START/PAUSE to turn load each on or o. The last character on the display changes from “-”
to “o” when an output is running.
4 If the output does not work, a long descending tone is played.
5 Press POWER to exit HO sub-mode back to 'dP' sub mode, press POWER button again to exit
completely.