Alternative Exhaust Directions
This dryer car] be vented from the rear, right, left, and bottom side of the cabinet and must be
exhausted to the outdoors.
Note:
The gas dryer car] not be exhausted directly through the right side of the cabinet.
Dryer Exhaust to Right, Left or Bottom of Cabinet
a Detach and remove the bottom, right or
left side knockout as desired. Remove the
screw inside the dryer exhaust duct and
save. Pull the duct out of the dryer. Protect
sharp edges around the knockout and
exhaust opening with tape.
Remove
screw
and save
iiiiiiiiiiiiii
iiiiiiiiiiiiii
iiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiii
Cut the duct as shown and keep portion A.
desired knockout
(oneonly)
Fixir/g hole
Tab Location
Through the rear opening, locate the tab in the
middle of the dryer base. Lift the tab to about
45° using a fiat blade screwdriver.
Bendtab
UF
Adding New Duct
Reconnect the cut portion (A) of the duct to
the blower housing. Making sure that the
shortened duct is aligned with the tab in the
base. Use the screw saved previously to secure
the duct in place through the tab on the dryer
base.
Fixing I
Hole _1 P°rti°n"A"_
exhaust
17
To Next Page
Loading...
