Exhaust Venting
Fire Hazard
Use metal exhaust duct°
Do not usea plastic exhaust duct°
Do not usethin metal Dil exhaust ducto
Failuireto do so caniresult in death oirfire°
1 Readthe exhaust section (pages ] 3 - 18) before installing the exhaust system to determine the
maximum allowable exhaust duct length.
Do not use sheet metal screwswhen assembling ducting. Always use suitable duct tape. Never
use plastic or thin metal foil flexible exhaust material.
2 The exhaust outlet islocated close to the center of the rear of the dryer. Makesure you join the
exhaust duct to the dryer with duct tape only. This will prevent lint and dust from escaping from
the dryer and exhaust system.
!
@ Exhaust outlet
298mm (11 3/4")
3 The exhaust vent car] be routed up, down, left, right or straight out the back of the dryer. Referto
diagram.
19
To Next Page
Loading...
