Fisher & Paykel Dryer - Electric Power Supply; Power Supply Cord Requirements for U.S.A

Electric Power Supply for Gas and Electric Dryers
Power Supply for Electric Dryers: (for Canada only)
120/ 240V or 120/ 208 V of 60 Hzsinusoidal supplied via an
individual branch circuit with a 30 ampere fuse or breaker in
each of the lines.
a Connected to a 30 ampere wall receptacle as shown
a The installation conforming to local codes. Do not modify the
plug to fit a different outlet
iiiiiiiiiiiiii
iiiiiiiiiiiiii
iiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiii
Electric Power Supply for Gas Dryers:
120V 60 Hz sinusoidal supplied via a circuit protected with a
15or 20ampere fuse or breaker.
Connected to a wall receptacle as shown
The installation conforming to local codes and/or the current
CSAC22.1 Canadian Electrical Code part 1.
ii
Power Supply Cord Requirements for U.S.A
Emoct_icShockHozo_d
Neve_leave the cove_off of the terminal block°
Failure to do so will result in death o_dect_'k: shock°
4-wire Connections must be used for Mobile Home Installation)
Note:
SineJanuary 1, 1996,the National Electric Code requires that new constructions utilize a 4 ,,ire
connection to an electric dryer.
1 Turn off the circuit breaker(s)(30 amp)or remove the dryer's circuit fuse at the electrical box.
2 Besure the dryer cord is unplugged from the wall receptacle.
:3Remove the power cord coverlocatedatthe lower back.
4 Remove and discard ground strap. Keep the green ground screw for step 7.
5 Installs/4"ULrecognized strain reliefto power cord entry hole. Bringpower cord through strain relief.
6Connectpowercordasfollows:
A.Connect the 2 hot lines to the outer screwsof the terminal block (marked L1and L2).
B.Connect the neutral (white) line to the center of the terminal block (marked N).