32
8.9 Removing the Drain Pump
8.10 Removing the Wash Pump & Heater Assembly
• Remove the product from the joinery.
• Remove the base panel from the machine, and
disconnect the flood switch assembly.
• Remove the wiring harness to the drain pump.
• Depress the clip and rotate the drain pump
anticlockwise to release.
• When reassembling the drain pump, ensure the
lock clip engages to secure the pump.
• Disconnect and remove the product from the
joinery.
• Remove the screws securing the base panel from
the machine, and disconnect the flood switch
assembly and remove base panel completely.
• Sometimes laying the product on it’s back is
the easiest option to service, however ensure no
hoses are damaged and the floor is covered to
stop any possible damage.
• Remove the wiring harness and earth wires to
the wash pump and element assembly.
• Remove the hose clamps securing the supply
hose from the sump and supply hose to the
spray arms.
• Pull the hoses off the sump fittings.
• The wash pump is hung from 2 rubber
grommets. To release the wash pump slide the
pump backwards to release.
rubber
grommets
slide
backwards
The FC6 model uses a different wash pump, but the
same principle is used to service.
8 SERVICING THE COMPONENTS
To Next Page
Loading...
