4. If the problem occurs with the front right, simmer burner
Check that there is enough gas coming through the 'electrode' port at the rear of the burner skirt,
to maintain a stable flame. Try adjusting the low setting.
5. If the problem occurs with the front left 'triple ring' burner. Install a new electrode,
(Part No. 531603). Check that the ceramic body has not been damaged.
6. Check each burner lights and doesn't continue sparking.
10.4 Flame Goes Out on Low Setting
Check the cooktop and regulator are set up for the correct gas type and pressure (factory set for
NG).
Check the burners low setting is correct (see Section 3.1).
10.5 Flame is Distorted or Large and Yellow
Check the cooktop and Regulator are set up for the correct gas type and pressure (factory set for
NG).
Check the burner components including the burner cap are sitting correctly.
17
To Previous Page
Loading...
