WATER LEVELS
10
The agitator has 5 levels marked on its stem that can
be used to help you select the correct water level.
Select the correct water level by using the mark
nearest to the top of the load.
• The levels marked on the agitator do not
correspond exactly to the level of the water.
They indicate the level of dry clothes suitable
for the water level.
• Your Smart Drive may occasionally add water
during agitation. This is to maintain the water level
due to the release of air trapped in the garments.
• The medium/high and medium/low settings are
available on the EXCELLENCE models only.
• Out of balance loads, tangling or splash-over can
be caused by selecting a water level that is too high.
Your Smart Drive can automatically select the
appropriate water level for the load.
1. Place your clothes in the machine.
2. Select the wash cycle (Select AUTO if not
automatically selected).
3. Press START/PAUSE.
During fill the machine will pause occasionally to
sense the water level. The machine will check if the
water level is correct by using a series of 2 different
agitate strokes. A slow stroke to sense the load and
an agitate stroke to mix the load. (This may take
over a minute.) If it detects that the water level is not
high enough, it will fill with more water and
check the level.
• When washing an unusual load, eg large bulky
garments or pillows, we recommend you
manually select the water level and select the
Delicate cycle.
• Manually select the water level if there is already
water in the bowl.
Actual level of water
High
Med/high
Medium
Med/low
Low
Note: If you feel the Auto
Water Level does not fill
to the correct level, you
can adjust the level the
machine selects.
(Refer to Option
Adjustment instructions
pages 19 and 22).
MANUAL WATER LEVEL
SELECTION
AUTO WATER LEVEL
-
models only
To Next Page
Loading...
