Fisher & Paykel GW711 - Adjusting Wash Options: Water and Beeps; Customizing Water Fill and Beep Settings

CHANGING PRE-SET OPTIONS 17
Temperature Setting Adjustment
Colder Hotter
Automatic
Out of
Balance
Recovery
Temp
Setting
Rinses
2 Deep
1 Deep
Spray & Deep
1. Press START/PAUSE and hold down. Press POWER.
2. The diagram below shows how the lights relate to the options you can change. It
also shows what lights will be on when you first enter the Option Adjustment Mode.
Use this diagram to help you adjust the options on the model.
3. Use the buttons on the panel to change the pre-set options.
Temperature Setting Adjustment
Colder Hotter
Autowater Level
Less Water
More Water
Automatic
Out of
Balance
Recovery
Beeps
Temp
Setting
Water
Saver
Rinse
Volume
Rinses
15 Beeps
5 Beeps
None
Hot
Warm
Cold
More
Standard
Less
2 Deep
1 Deep
Spray & Deep
Water
Saver
Rinse
Volume
Rinses
More
Standard
Less
2 Deep
1 Deep
Spray & Deep
Use this diagram to help you adjust the options on the model.
2408 SmartDrive U&C.qk 15/3/02 09:38 Page 19