Model Capacity Depth Width Height* Height (Lid Open)
GW711 7.5kg 650mm 650mm 1020-1050mm 1410-1440mm
GW611 6.5kg 600mm 600mm 1020-1050mm 1360-1390mm
GW511 5.5kg 560mm 560mm 1020-1050mm 1320-1350mm
MW511 5.5kg 560mm 560mm 1020-1050mm 1320-1350mm
MWC11
CHANGING PRE-SET OPTIONS
20
OUT-OF-BALANCE
RECOVERY ROUTINE
SPECIFICATIONS
MACHINE INFORMATION
23
REGULAR
light on
= automatic
recovery
REGULAR
light off
=machine
stops
When your Smart Drive is spinning it can sense if the
wash load is out-of-balance and will stop and re-try
spinning up to 3 times. If it still senses an unbalanced
load there are two options the machine can take.
• AUTOMATIC RECOVERY OPTION
Your Smart Drive will try to automatically correct
the out-of-balance load. It will fill with water and
agitate to redistribute the load before trying to
spin up again.
• MACHINE STOPS OPTION
Your Smart Drive will stop, give a short burst of
beeps every 5 seconds, and the RINSE or SPIN
light will flash. You must redistribute the load
more evenly yourself. (Use this option if you wish
to conserve water).
• Electrical Supply 220-240V, 50Hz Sinusoidal, 165W
• Inlet Water Pressure Max. 1MPa (150 psi) Min. 20kPa (3 psi)
• Standpipe Height 850-1200mm
Note: Exact height of your Smart Drive is dependent on how far the feet are inserted
onto the base of the machine.
*Height is measured to the highest point on the console.
To Next Page
Loading...
