INSTALLATION ENVIRONMENT 3A
WATER SUPPLY
DRAINING
AUTOWASHER SAFETY
• For best operating conditions your hot water should
be approximately 65ºC. Your cold water should not
exceed 35ºC or your hot water exceed 75ºC.
Temperatures above these may cause the machine
to fault or cause damage to the machine.
• If you have an uncontrolled water heating source
(eg a wet back or solar heating system) you should
fit a Safe Valve. This will ensure the hot water
temperature remains within safe limits.
• Inlet water pressure:
Max.1MPa (150 psi) Min. 20kPa (3psi)
• Minimum height of taps to clear the top of the
machine is 1150mm.
• Regularly check that your standpipe or tub is free
from lint or other obstructions, which may affect
how your machine works or may cause flooding.
• In multi-storey apartments or any upper floor, the
machine should be installed on a drained floor.
• Draining must comply with local by-laws.
• This autowasher is not intended for use by young
children or infirm persons without supervision.
• Your Smart Drive can now be opened while it is
filling and agitating, supervise young children to
ensure they do not play with it.
• Caution: If you are using an extension cord or a
portable electrical outlet device (eg multi-socket
outlet box), ensure that it is positioned so that it
does not come into contact with water or moisture.
HOT ‘N’ SAFE VALVES
AVAILABLE ARE:
RMC TVA 50HF
RMC TVA 75HFS
Adjustable between
35ºC - 55ºC
RMC TVA 50HP
For instantaneous
gas hot water supply
ACCESSORIES AND SPARE PARTS
Available from your Fisher & Paykel Dealer or Authorised Service Centre.
Inlet Valve Cap Part No. 388491
Hose Inlet Long (2m) Part No. 422680
Hose Inlet Large Bore Part No. 426123
Drain Hose Extension Part No. 425627p
Power Cord If the Power Cord of your autowasher is damaged it
must be replaced by a Fisher & Paykel Authorised
Service Centre, as it is not a standard power cord.
To Next Page
Loading...
