UNPACKING/INSTALLATION 1A
20mm maximum
PULL HOSE THROUGH
FLEX HOSE
GUIDE APART
Standpipe 850-1200mm
To ensure the best performance from your new
Smart Drive please follow the instructions below.
REMOVING THE PACKAGING
1. Remove the outer packaging.
2. Tilt the machine backwards and walk it off the
bottom packer one foot at a time.
3. Remove the bottom packer from under the
machine by pulling it out the front.
4. Lift the lid and remove the bowl packer from the
bowl.
5. Remove the hoses and accessories.
6. Keep the bottom packer and bowl packer in case
they are required for future transit.
In your autowasher you will find:
• 4 rubber inserts for the levelling feet (joined
together).
• 1 hose guide.
• 2 white inlet hoses.
• 1 box of Persil/Omo Concentrate.
1. Carefully pull the black drain hose out from the
back of the machine by pulling the exposed part of
the hose downward and outward.
2. To guide the drain hose over the tub or standpipe
the hose guide MUST be fitted to the drain hose.
TO PREVENT SYPHONING:
- the drain hose should not extend more than
20mm from the end of the guide.
- the height of the standpipe or tub should be
between 850-1200mm.
The drain hose can be trimmed to length.
3. Place the drain hose in the tub or standpipe.
DRAIN HOSE
UNPACKING
Please ensure that
the bottom packer
has been removed
before operating
your machine.
To Next Page
Loading...
