58
8.13 Removal of the Power board.
•
Remove the product from the joinery to gain
access to the top panels.
• Remove the top panel.
• The power board is held in by 9 plastic clips,
squeeze the clip to release.
• Remove the wiring and harnesses and transfer
to the new PCB.
• Once assembled and tted, check the model ID
is correctly set for the product you are working
on, refer to section 6, page 37 & 38.
8.14 Removal of the Temp Sensor
•
Remove the product from the joinery to gain access
to the temperature sensor harness.
• Remove the door to access the sensor (optional)
• Remove the screws on the inside oven cavity
securing the temp sensor.
• Remove the top panels to gain access to the sensor
harness and unclip it, thread the harness through
the clips and remove the sensor from the oven
cavity.
To Next Page
Loading...
